RedMax SGCZ2500S Especificaciones descargar pdf (Pagina 13)

5. Set up

 13 

SE4

■ BLADE CUTTERCASE (SE4)

The blade has very sharp edges. Be sure to use

protective gloves whenever handling it.

1. Remove the fastening screw (long) and the lock

screw (short) from the cuttercase.

2. While aligning the locking holes (cuttercase hole,

spacer hole, and shaft casing hole) install the

cuttercase assembly to the shaft casing. If it will

not bottom, twist the case slightly back and forth.

3. Align the locking holes and make sure that the

locking screw (short) is fastened to the bottom

by hand, then secure it with wrench.

(1) Cuttercase

(2) Locking holes

If the locking screw is tightened up with the holes

out of alignment, the cuttercase may be damaged.

4. Fasten the cuttercase fastening screw (long).

■ DEBRIS GUARD

Install the debris guard onto the shaft housing

approx. 1.2inches (30mm) away from the

cuttercase. Fasten the clamp uniformly. (SE5, SE6)

NOTE

WARNING

SE5

SE6

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sin comentarios

RedMax SGCZ2500S Especificaciones Pagina 13