RedMax RECIPROCATOR SGCZ2500S Manual de usuario

OWNER/OPERATOR MANUALRECIPROCATORT3066-93110(103)SGCZ2500SThe engine exhaust from this productcontains chemicals known to the Stateof California to c

❲10❳• IF SOMEONE COMES1. Guard against hazardous situations at all times.Warn adults to keep pets and children awayfrom the area. Be careful if you ar

❲11❳4. For safe operationrefill the tank of the unit in any place where thereis a boiler, stove, wood fire, electrical sparks,welding sparks, or any o

MOUNTING ENGINE (SE1)1. Install the engine to the driveshaft so that thecylinder head and the stop switch may come onthe same side. 2. Using attache

5. Set up❲13❳SE4 BLADE CUTTERCASE (SE4)The blade has very sharp edges. Be sure to useprotective gloves whenever handling it. 1. Remove the fastening

• Gasoline is very flammable. Avoid smokingor bringing any flame or sparks near fuel.Make sure to stop the engine and allow itcool before refueling t

container to avoid mixing up with gasoline orother containers.6. Indicate the contents on outside of container foreasy identification. FUELING THE U

❲16❳ STARTING ENGINEThe cutting head will start rotating upon theengine starts.1. Rest the unit on a flat, firm place. Keep thecutting head off the g

7. Operationengine while pulling the throttle lever. ADJUSTING THROTTLE CABLE• The normal play is 1 or 2mm when measured atthe carburetor side end. R

machine control. 3. Since the blade does not cause cut grass towrap around the neck, you need not to stopoperation to remove such wrappers. What'

❲19❳8. MaintenanceMA1every every every25 50 100system/compornent procedure before hours hours hours noteuse after after afterfuel leaks, fuel spillage

❲20❳8. MaintenanceTo Sharpen Blade: 1. When the corners of cutter become rounded andthe cutting edges become dull, resharpen usinga small disk grinder

8. Maintenance❲21❳• Make sure that the engine has stopped and iscool before performing any service to themachine. Contact with moving cutting heador h

❲22❳machine and have it repaired immediately. • Note that failing to do so may result in theengine catching on fire. SPARK ARRESTER• The muffler is e

❲23❳9. Storage• Oil the blades. • Aged fuel is one of major causes of enginestarting failure. Before storing the unit, empty thefuel tank and run the

❲24❳10. Troubleshooting guideCase 1. Starting failure CHECK PROBABLE CAUSES ACTIONfuel tank ➞ incorrect fuel ➞ drain it and with correct fuelfuel filt

11. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/orreplacement. 2. KOMATSU ZENOAH does not warr

11. Parts list ❲26❳Fig.1 DRIVE UNIT (S/N: 000101 and up)Fig.2 CASE UNIT (Contended with Engine) (S/N: 2842 and up)

Fig.1 DRIVE UNIT (S/N: 000101 and up)Key# Description Part Number Q'ty NOTEKey# Description Part Number Q'ty NOTE1 MISSION ASS’Y T3065-1100

Fig.3 ENGINE UNIT (S/N: 2842 and up)❲28❳11. Parts list

❲29❳Fig.3 ENGINE UNIT (S/N: 2842 and up)Key# Description Part Number Q'ty1 CYLINDER 4810-12111 12 GASKET, base 4810-12210 13 BOLT, M5x22 1850-12

SAFETY FIRSTInstructions contained in warnings within thismanual marked with a symbol concerncritical points which must be taken intoconsideration to

The California Air Resources Board and KOMATSU ZENOAH are pleased to explain theemission control system warranty on your 1995 and later small off-road

EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY, KOMATSU ZENOAHAMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WIL

© Printed in JapanPièces en rapport avec les émissions de gaz d'échappement : KOMATSU ZENOAH AMERICA INC., parl'intermédiaire de n'impo

2. Specifications SGCZ2500SOverall size(LxWxH)·························································· 76.0(1930)x9.8(250)x9.8(250) in(mm)Dry weigh

For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mistake

❲6❳4. For safe operation1. Read this manual carefully until youcompletely understand and follow all safetyand operating instructions. 2. Keep this man

❲7❳b. At night, at times of heavy fog, or at any othertimes when your field of vision might belimited and it would be difficult to gain a clearview of

❲8❳ BEFORE STARTING THE ENGINE1. The area within a perimeter of 50 feet (15m) ofthe person using the product should beconsidered a hazardous area int

❲9❳Never place the throttle into the high speedposition when starting the engine.2. After starting the engine, check to make surethat the cutting atta